Panasonic 50" plasma 3D // Viera
Onkyo TX-SR604
KEF 2005.2 satelites (5.1)
KEF psw2010 10" power sub/250Watts
Panasonic DMP-BDT310 // 3D player (twin hdmi)

note: hdmi 1.4 cables running from panasonic player. main out to plasma (video only setting) sub out to receiver (audio signal only) in PCM mode - sending lossless to the 1.1 hdmi receiver.

note#2: Speakers all line up to ear height when in seating positions

The bulk of my blu's now housed in study shelving. Boxsets will be showcased in the black wall shelf, diagonal facing (as on top shown here)

It used to be nestled (under a chair) against the cabinet with the TV/speakers on. Now it is better calibrated and as you see, in a corner!

Distance cal: L/R front- 9 feet // Centre - 8 feet // surrounds L/R - 3 feet
Crossover: sub - 80Hz // fronts - full band // surrounds - 100Hz // centre - 100Hz
Double bass: Off // Sub - +1 level calibration // other speakers - zero

Not 100% sure of this latest experimentation. Crossover on the AVR is 80 I believe and on the sub it's lower than that? More like 60 at the moment..

Kitchen to the right of picture. This position is 12 foot from the front door/door to the study. Horrid curtains and light management I know lol Getting shutout blinds soon the quotes are done.

Right on that couch is where I watch from. Visitors be damned.

I do like KEF. It's only 10" but it's beefy and tight also.

About to put in Australian Village roadshow release of theatrical LOTR: Fellowship. Unique release as it has the same 6.1 DTS HDMA track as the Extended editions. Win for a TC flagwaver like me.

Gallery rating:

(4.7) (5 ratings) Show ratings

Gallery rating:

(4.7) (5 ratings) Hide ratings

Member		Apr 28, 2012 09:09:36
Member		Mar 23, 2012 15:38:52
Member		Feb 12, 2012 17:01:59
Member		Feb 11, 2012 18:18:52
Member		Feb 09, 2012 15:01:01
Member		Feb 09, 2012 11:46:04

Comments (7)

Show comments

Comments (7)

Hide comments

kuatolives  » Mar 30, 2012 03:56 PM

Using an LFE input on a sub bypasses the sub's internal crossover.

riverbelow  » Feb 18, 2012 08:46 AM

Thanks! Appreciate that.

rkolinski  » Feb 12, 2012 05:02 PM

Nice looking home theater; 10/10!

riverbelow  » Feb 09, 2012 12:27 PM

I can't zero out anything. The AVR allows me to go low as 80Hz for LFE, and the sub allows me to go to 40. So I go as low as possible for the AVR and then experimented with the subs XO settings...its hard to tell which sub crossover is best. Should it be higher than the receiver setting or lower, or the same...?

Xenomorph  » Feb 09, 2012 12:03 PM

Correct me if I'm wrong, IRT your sub settings. If you have the AVR x-over at 80 you should zero out your sub's x-over? Or in your case, zero out the AVR and set the sub to 80? Nice setup btw..

RonAlam  » Feb 09, 2012 11:32 AM

looking good, now bury the the rear channel speaker wire, and your set :-)

Bluvette  » Feb 09, 2012 10:25 AM

Sweet room, love the setup. Awesome gear, love the speakers. 10/10 if I could rate your setup.

	Chitty Chitty Bang Bang   $19.99 $4.99
	Valkyrie   $19.99 $4.99
	Sleeping with the Enemy   $16.99 $4.99

Best Blu-ray Movie Deals »